INSTALLATION, OPERATION & MAINTENANCE OF THE SPRITE HAND-HELD SHOWER FILTER

Hand-Held Shower filter

INSTALLATION

1. Remove existing showerhead from Shower Arm

2. Screw Hose Bracket onto Shower Arm

3. Remove Paper Seal from end of Shower Filter Handle.

4. Insert Rubber Washers into the Couplers(2) at each end of Shower Hose

5. Screw one end of Shower Hose onto Hose Bracket

6. Screw Shower Filter Handle onto other end of Shower Hose

7. Place Shower Filter Handle into Hose Bracket


Flush unit for a full five(5) minutes before using(upon installation or after installing a new cartridge).


OPERATION

1. Before entering the shower:

a. Turn the shower water to the "full hot" position.

b. After hot water is flowing through the unit, cool to the desired temperature.

2. Enter the shower and enjoy


MAINTENANCE

The Hand-Held Shower filter can be easily maintained by performing the following procedures monthly(or as needed) in order to maximize filtration performance and water flow:

1. Unscrew Showerhead from Handle

2. Remove Cartridge from Handle

3. Reverse and insert Cartridge back into Handle

4. Screw Showerhead onto Handle

5. This procedure may be repeated as necessary.

NEW CARTRIDGE REPLACEMENT

The Shower Filter Cartridge should be replaced every 6 months or sooner(according to individual water conditions) by performing the following procedures:

1. Unscrew Showerhead from Handle

2. Remove used Cartridge

3. Remove Paper Seals at each end of new Cartridge(model HC)

4. Lubricate O-rings at each end of Cartridge with a small amount of Vaseline

5. Insert Cartridge into Handle

6. Screw on Showerhead to Handle

7. Flush for a full five(5) minutes before using.